how do i just listen to one talkgroup??
i know how to MAN a freq channel....but not a talkgroup..thanks
talkgroup
This is from my notes I saved long time ago.
--------------
Here is the correct way to hold an ID...
PGM > TRUNK
Enter ID or select one that's already entered using up/down arrows. Once
it's on screen, press FUNC > TRUNK
This is better than waiting for the TG to transmit. The second way to hold
a TGID, is to hold the TRUNK key for two seconds while the TG is active.
The best way is to wait for a transmission on the TG you want to listen to, and hit "PAUSE."
-----------------
--------------
Here is the correct way to hold an ID...
PGM > TRUNK
Enter ID or select one that's already entered using up/down arrows. Once
it's on screen, press FUNC > TRUNK
This is better than waiting for the TG to transmit. The second way to hold
a TGID, is to hold the TRUNK key for two seconds while the TG is active.
The best way is to wait for a transmission on the TG you want to listen to, and hit "PAUSE."
-----------------
I'll lock out any talkgroups that I don't want in the mix. That way I can isolate one or a couple talkgroups, and just unlock the ones I need to follow an event as needed.
I also picked up another trunking scanner from ebay so I can have isolated talkgroups being scanned at the same time.
But I'm sure there are other good ways to do it that someone here can pass on too.
Hope this helped.
I also picked up another trunking scanner from ebay so I can have isolated talkgroups being scanned at the same time.
But I'm sure there are other good ways to do it that someone here can pass on too.
Hope this helped.